Repair works

Prior to repair an injury analysis is carried out, in this, we inspect for gross pliers cleaning, disassembly and surveying control the wear and the degree of damage. These are visually documented.

You will receive the results in the form of a meaningful findings. Concrete and clear statements to found state they obtained by the imaged descriptions.

Here are a few examples of repaired lifting accessories.

Lifting trunnions and washers from stainless steel material 1.4541.

Characteristics:

• lifting accessories: block tong
• use: absorb and transport blocks
• load capacity: 5.0 t
• dead load: 0,6 t
• cross section: 500 mm

Work carried out:

• reamed and bushed worn pivot bearings
• various metal components directed
• renewal of the heat- and wear-resistant surfacing
• new production of several drive shafts
• new paint
• final UVV inspection

Characteristics:

• lifting accessories: multiple billet tongs
• use: absorb and transport several billets
• load capacity: 10 t
• dead load: 2,5 t
• cross section: 1100 mm - 300 mm

Work carried out:

• reamed and bushed worn pivot bearings
• Various metal components directed
• renewal of the heat- and wear-resistant surfacing
• new production of several drive shafts
• new paint
• final UVV inspection

Characteristics:

• lifting accessories: Traverse
• use: pick up and transport scrap container
• load capacity: 8.8 t
• dead load: 3,2 t
• cross section: 600 mm

Work carried out:

• review of critical areas by dye penetrant
• directed gripper arms and reinforced
• grinded various weld connections and rewelded
• renewal of the insulation material
• check the limit stops
• new partial painting
• final UVV inspection

Characteristics:

• lifting accessories: pliers with motorized slewing
• use: picking up and transporting slabs and blocks
• load capacity: 20.0 t
• dead load: 5,2 t
• cross section: 1520 mm - 425 mm

Work carried out:

• reamed and bushed worn pivot bearings
• various metal components directed
• renewal of the heat- and wear-resistant surfacing
• new production of several drive shafts
• new partial painting
• final UVV inspection

Characteristics:

• lifting accessories: motor clamshell
• use: picking up and transporting bulk materials
• dead load: 2,145 t
• content: 1.4 m³

Work carried out:

• renewal of the hydraulic hoses
• drive shafts expanded, checked, greased and reinstalled
• new partial painting
• final UVV inspection